![]() these configs here also give you 256mb of ram. now open up /opt/retropie/configs/macintosh/basiliskii.cfg and replace its entire contents with this: extfs / However, you still need a copy of MacOS and a Macintosh ROM image to use Basilisk II. That is, it allows you to run 68k MacOS software on your computer, even if you are using a different operating system. ![]() Install the full version of 7.0.1 then the System 7 Tune-up 1.1.1 from the Legacy Software Recovery CD. Basilisk II is an Open Source 68k Macintosh emulator. so any new files you want to add, just dump them in there. Setup and run Basilisk II with at least those 3 volumes: boot, legacy CD, and the drive/volume you’re updating. This also is set up so you have your macintosh roms folder as an external drive. To boot the bootdisk from this guide, the Mac Model ID should be set to MacIIci (MacOS 7.x). now open up /opt/retropie/configs/macintosh/emulators.cfg and replace the info with this: basilisk = "/opt/retropie/emulators/basilisk/bin/BasiliskII -rom /home/pi/RetroPie/roms/macintosh/QUAD650.rom -disk /home/pi/RetroPie/roms/macintosh/MacOS-753 -extfs /home/pi/RetroPie/roms/macintosh -config /opt/retropie/configs/macintosh/basiliskii.cfg" Switch to the Memory/Misc tab of the Basilisk II GUI. but you can put it there still if you want. Ok put the files in you macintosh roms folder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |